|
|
|
|
|
|
|
This is a tough black rubber similar in feel to a car tire. It is used not only for making concrete molds and stamps, but also for making hard durable rubber parts for machinery or automotive applications.
This one to one
mix ratio polyurethane rubber is used for making molds for concrete. The smallest container in
the picture contains a mold release, and is included with each small kit.
View Technical Data Sheet
View Concrete Form Release Page (Helps remove concrete from mold)
|
|
|
AeroMarine Concrete
Molding and Stamping Rubber Price Page
|
AeroMarine Concrete
Molding and Stamping Rubber
1/2 gallon kit, makes 1/2 gallon, includes mold release |
$35.00 |
|
Ships Immediately
|
AeroMarine Concrete
Molding and Stamping Rubber
2 gallon kit, makes two gallons, includes mold release |
$88.00 |
|
Ships Immediately
|
AeroMarine Concrete
Molding and Stamping Rubber
ten gallon kit, makes ten gallons, does not include mold release |
$352 |
|
Ships Immediately
|
AeroMarine Concrete
Molding and Stamping Rubber
drum kit, makes 110 gallons, does not include mold release |
$3063 |
|
Call to place order |
These
freight rates apply to the lower 48 states. Freight
outside this area will be more expensive. For more information or
for custom rate quotes just call me at (877)342-8860 and we can discuss the most
efficient method for you to receive your products.
Most orders are shipped within 24 hours- Weekend orders are shipped on
Monday. This product ships D.O.T. Non-Regulated- there are no
hazardous material fees involved. |
Properties |
| Mixed Viscosity |
Thin liquid |
| Mix Ratio |
1 :1 by volume |
| Pot Life,
minutes @ 77ºF |
5 |
| Cure time, hours @77ºF |
12 |
| Tensile strength |
750psi |
| Color |
Black |
| Shrinkage |
negligible |
| Durometer |
75 shore A |
| Elongation at break |
500% |
|
Molded Concrete Birdbath |
|
AeroMarine concrete molding and stamping rubber is a
tough rubber that resembles a rubber shoe heel
|
|
Use between 65° and 75°F. Thoroughly mix parts “A” (black)
and “B” (clear) until a consistent black color is achieved. Pour within 5
minutes.
A mold release must be used when pouring this product against
another surface. AeroMarine Release #7 is the standard release for
this product. It is a soft paste, and may be thinned with alcohol or naptha. To release the concrete easily from the mold, many customers use motor oil
or castor oil.
This is also an excellent choice for making clutch and brake pedals, motor mounts, or door
trim rubber for automobiles. Call John Greer at 1(877)342-8860 for
advice on how to make a mold for these items.
|
|
|
|
© 2010 AeroMarine Products │ Policies | Samples |
|
|
|
